Skip to content
SugarPaws
Get Support

Log an insulin dose

To log a dose, open the Add tab, switch the segment to Insulin, spin the wheel to the number of units you gave, and tap Save Insulin Dose. The dose is written immediately, stamped now unless you changed the time, tagged with the insulin type currently selected in Settings, and the last-dose strip at the top updates. Logging a dose also silences a daily insulin reminder due within the next hour — see Reminders.

Range0.5 to 99.0 units
Step0.5 units
PrefillYour last dose for this cat, rounded down to the nearest half unit and kept inside 0.5–99; 1.0 if there is none. Set when the Add tab opens; after each save the wheel goes back to 1.0
DisplayAlways one decimal (2.0 units)

A wheel rather than a keypad because a dose is one of a small set of values, and a wheel cannot produce a number you did not see. The prefill rounds down, never to nearest — an imported 2.3-unit dose prefills as 2.0, not 2.5 — because over-dosing is the dangerous direction; you can always spin it up. What is saved is exactly what the wheel shows.

The prefill is taken when the Add tab appears, not after every save: once you save a dose the wheel returns to 1.0, and it picks up the new last dose the next time you come back to the tab. Two edge cases come from the 0.5–99 limits of the wheel — an imported 0.25-unit dose prefills as 0.5 (the one case that rounds up), and an imported dose above 99 units prefills as 99.

Doses off the half-unit grid (0.25 u, 2.3 u) can only enter the app through CSV import; they display with two decimals where needed and export as such.

The dose is stamped with the Insulin Type shown below the wheel — the one selected in Settings › Insulin Settings (default Lantus (Glargine)), or your custom name if you chose Custom. You cannot change it here; the row is read-only with an ⓘ button beside it that opens the Insulin Profile sheet for the type selected in Settings (onset, peak and duration in hours, and a key to the activity chart). With Custom selected the sheet is titled Custom and shows the generic Custom profile, not your custom name. If you switch insulins, change the setting first, then log.

The recorded type matters later: the insulin activity curve models each dose with the insulin it was recorded under, so past doses keep their shape when you change the setting.

Same as for readings: the Time picker is pre-set to now and only used if you change it (no future times; resets after each save), and Notes (Optional) takes up to 500 characters. Switching to the Glucose segment and back keeps your selection.

Before writing, SugarPaws shows one Check before saving dialog listing every applicable warning, ending Double-check before saving., with Save Anyway and Cancel. Two conditions trigger it:

WarningWhen
You logged an insulin dose N minutes ago. Giving insulin twice can cause dangerously low blood sugar.The most recent dose for this cat is within 60 minutes of this one’s time (either side — a backdated entry counts too). Less than a minute ago when under a minute.
N units is an unusually high dose for a cat.More than 15 units. Typical feline doses are 1–6 units.

Both can appear in the same dialog. Confirming one never skips the other.